Send mail dresse så måske jeg kan fInde ud af at sende billederne også
Instructions - version 1
1. Switch the phone off and removed the battery cover and battery.
2. Remove 2x Torx screws (these hold the front cover on).
3. Remove 2x Philips screws (these hold the back cover on).
4. Made a note of all the clips by looking at the new casing.
5. Used a thin plastic shim to lever the back cover away from the phone (must be careful when doing this so as to not damage the inside of the phone in any way)
6. Remove back cover whilst being careful not to touch the camera lens.
7. Used the same method to remove the front cover being extra careful not to touch the LCD screen (also note – The keyboard is not attached to the phone on one side so be careful otherwise you may accidentally rip it off)
8. Made sure that both the screen on the new cover and the LCD screen on the phone were both clean and free of dust.
9. Replaced the front and back cover.
Instructions – version 2 (dismanteling only – need to assemble in the same way)
1. Remove the battery cover (lol that will be the easiest thing you do in this mood) Unscrew the 4 screws you see, and keep them somewhere safe
2. Now, use something with a blunt blade and skim around the edges of the back cover, turn the blade now and again and that will release the catches.
3. Use this same technique for the front cover, be careful of the lcd though, expensive to replace
4. Now you should have something like this. Dont be fooled my young friend, we are far from done
Remove the keypad system: Just rips it off, be gentle of course, its like unplugging anything, it really is that easy.
2. Next lets attack the lcd, exactly as the keypad......just unplug it from the board.
4. Hopefully you now have this:
5. And what do you know, yes you guessed it....lets unplug the camera from the baord aswell.
6. Now, lift the board free, use the knife again to unclip it. And pull it out from the base connector.
PART 3 - The Camera
1. OK, so now the board is free from the case. What do we see? We see the camera lens and the ribbon. Now, unplug the ribbon from the actual camera, then lift it free.
2. Don´t forget to remove the little sticky pieces and the flash led's, they just lift free with a knife very easily.
Great, that´s it. ONe completely dissmantled K750i
RECOMPOSITION (The Final Act)
Now all we have to do is put our new housing on. Just retrace the steps and you will be fine. Couple of tips though, put the button in first....they can be tricky.
Then, once done lets hope you have something looking like this.